If necessary, do the Mocon Firmware Upgrade and the Communications Firmware ("Floppy Version") Replacement for a Maincon Processor. The replacement Maincon must also have the the same, or higher, Communications Firmware (“Floppy”) version. Are the programs on the hard drive Do I need a Haas Rep or am I screwed and have to rewrite them again Any help would be appriated. I did have a back up floppy, but it doesnt contain any of my new programs resently written. ![]() Note: To operate correctly, a replacement Maincon must have a Mocon firmware version that is the same as, or higher than, the version of the initial Maincon. I use a Haas GR510 gantry mill and accidently deleted all programs on it one day while in a rush. Resetting SMART on an SSD (hours powered on) Weve been bitten by a known issue on SanDisk SSDs (Dell or HPE branded) where they hard fail after a certain number of hours powered on - 32768 or 40000 depending on the specific model. Note: When all of these procedures are completed, cycle the power (1) time. Important: When this procedure is completed, make sure that the correct optional functions are enabled. ENTER THE BILL TIME CODE IF AVAILABLE. If the Bill Time code is not available, be sure to increase the time to the maximum date permitted from the Haas portal. Wireless Intuitive Probe System (WIPS) Calibration.Umbrella Tool Changer - Set Parameter 64 - Z Axis Tool Change Offset.VMC Side-Mount Tool Changer - Set Parameter 64 - Z Axis Tool Change Offset.Umbrella Tool Changer - Spindle Orientation Offset - Parameter 257.Side-Mount Tool Changer - Spindle Orientation Offset - Parameter 257. ![]() After you install and initialize the software and use the Parameter Checker Program, do these procedures:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |